DragonFlyBSD

Loading if_ath works, but when configuring the device the system locks up/freezes.

System has been upgraded from 3.6-RELEASE via buildworld, installworld. Kernel is GENERIC_X64_86 and HEAD is 358af07.

Running "ifconfig ath0 up" works.

Then calling "ifconfig wlan0 create wlandev ath0" freezes the system.

I discovered the follwoing kernel message when trying to configure the device using /etc/rc.d/netif.

ath0: _ath_power_restore_power_state.refcount=0?

I also applied the change from http://lists.dragonflybsd.org/pipermail/commits/2014-June/270210.html via cherry-picking, but no changes.

The 3.6-RELEASE have been used successfully with the same hardware.

Here are the ath related snippets from the dmesg output:

wlan: <802.11 Link Layer>
ath_dfs: WTF module
ath_rate: <SampleRate bit-rate selection algorithm>

ath0.pci3.pcib3.pci0.pcib0.acpi0.nexus0.root0
ath0: <Atheros 2413> [tentative] mem 0xfebf0000-0xfebfffff irq 20 at
device 5.0 on pci3
ath0: Reserved 0x10000 bytes for rid 0x10 type 3 at 0xfebf0000

ath0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
ath0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps
24Mbps 36Mbps 48Mbps 54Mbps
ath0: AR2413 mac 7.8 RF2413 phy 4.5
ath0: 2GHz radio: 0x0000; 5GHz radio: 0x0056
ath0: Use hw queue 1 for WME_AC_BE traffic
ath0: Use hw queue 0 for WME_AC_BK traffic ath0: Use hw queue 2 for WME_AC_VI traffic
ath0: Use hw queue 3 for WME_AC_VO traffic
ath0: Use hw queue 8 for CAB traffic
ath0: Use hw queue 9 for beacons
ath0: using multicast key search
ath0: <Atheros 2413> [attached!] mem 0xfebf0000-0xfebfffff irq 20 at
device 5.0 on pci3
pci3: <ACPI PCI bus> [attached!] on pcib3
pcib3: <ACPI PCI-PCI bridge> [attached!] at device 20.4 on pci0